
6
3. CONTROL ELEMENTS
SPOTLIGHT
19 AC Inlet/Fuse holder
Standard IEC receptacle. Connect your equalizer an AC socket with the supplied
power cord. Before powering up your equalizer for the first time, make certain
the stated power requirement of the unit matches the voltage supplied by the
AC socket.
If the fuse blows, replaced with a fuse of the correct type only.
EQU231TWIN-MKII V2
O
N
O
F
F
P
O
W
E
R
SERIAL
MODEL
AC INPUT
95-120V /210-240V 60-50Hz
Rated Power Consumption 18W
FUSE:
210-240V: T100mAL 250VAC
95-120V: T200mAL 250VAC
REPLACE FUSE WITH CORRECT
TYPE ONLY
Apparaten skall anslutas till
jordat uttag nar den ansluts
till ett natverk
GND
LIFT
BALANCEDUNBALANCED
TIP/PIN 2
RING/PIN 3
SLEEVE/PIN 1
INPUT
BALANCEDUNBALANCED
TIP/PIN 2
RING/PIN 3
SLEEVE/PIN 1
OUTPUT
BALANCEDUNBALANCED
TIP/PIN 2
RING/PIN 3
SLEEVE/PIN 1
INPUT
BALANCEDUNBALANCED
TIP/PIN 2
RING/PIN 3
SLEEVE/PIN 1
OUTPUT
CHANNEL 1
CHANNEL 2
PUSH
PUSH
15
16
17
15
16
17
18
19
14
18
Ground lift switch
This switch is used to disconnect the signal ground from the mains and chassis
earth. If it is determined that the equalizer is the cause of hum or buzz in your
system due to a ground loop, move this switch to "lift" position.
14
Power switch
It switches the unit ON and OFF.
15 XLR IN/OUT connectors
The XLR connectors are balanced and are used to Input/Output the signal.
16 1/4" TRS phone IN/OUT connectors
The 1/4" TRS connector are balanced and are used to Input/Output the signal.
17 RCA IN/OUT connectors
The RCA connectors are unbalanced.
While you can use any input connector with any output connector, only
one set of these connectors is to be used at one time (The wiring and
connection, details please refer to 5.2 audio connection).
NOTE:
Kommentare zu diesen Handbüchern